some sugguestions for using electric forklift in summer
时间：2021-06-25 14:51 点击次数：
In this case, the following matters should be paid attention to in driving operation:
1．Before entering the summer vacation, make preparations in advance,
release the winter lubricating grease from the engine, drive axle, transmission, steering gear, etc.,
and add summer lubricating grease according to regulations after cleaning.
2．Clean the water channel, remove the scale of the cooling system, and dredge the radiator fins.
Always check the tightness of the fan drive belt.
3．Adjust the generator regulator properly to reduce the charging current of the generator.
4．During operation, attention shall be paid to prevent engine overheating.
The indicator reading of coolant temperature gauge shall be paid attention at any time.
If the temperature of coolant is too high, cooling measures shall be taken. To keep the quantity of coolant,
pay attention to prevent scalding caused by boiling of coolant when adding.
5．The temperature and air pressure of the tire shall be checked frequently.
If necessary, it shall be stopped in a cool place. The operation shall be continued after the temperature of the tire is reduced.
It is not allowed to reduce the pressure and cool by air bleeding or cold water, so as to avoid reducing the service life of the tire.
6．The brake efficiency should be checked frequently to prevent the failure of brake caused by aging,
expanding deformation and vaporization of brake fluid.
7．Adjust the density of electrolyte of the battery, and dredge the air vent on the battery cover,
keep the electrolyte 10-15mm higher than the diaphragm, and fill with distilled water as appropriate.
8．Before operation, we should ensure full sleep and keep energetic. If you feel tired, dull, and slow in response,
you should stop and rest immediately or wipe your face with cold water to cheer up your mind to ensure the safety of driving and operation.
9．Do a good job in heat prevention and cooling to prevent heatstroke.
Finally, check and confirm that all parts are in good condition before they can be put into normal use
