Precautions for safe operation of electric reach truck
时间：2021-07-17 14:33 点击次数：
Precautions for safe operation of electric reach truck
1. Do not step down the accelerator pedal before turning on the key switch,
otherwise the forklift will have fault code and the forklift will not run.
2. When the reversing lever is turned to the opposite direction during the operation of the forklift,
the electric brake will work, and the forklift will slow down and stop and slowly move to the other direction.
3. The steering system of this kind of electric forklift is full hydraulic steering. When the oil pump motor stops working,
the steering will be very difficult. It is necessary to start the oil pump motor to realize the steering easily.
4. t is forbidden to press the accelerator pedal and brake pedal at the same time.
5. It is forbidden to discharge excessively and charge in time when using,
and it should be recharged once a week when shelving for a long time.
6. Check the battery liquid level of the electric forklift irregularly.
If it is lower than the calibration line, add distilled water in time.
Do not add tap water, river water and mineral water, so as to avoid the internal self discharge fault of the battery due to the mixture of impurities.
Do not add electrolytic hydraulic pressure, otherwise the electrolyte concentration will increase and the battery service life will be shortened.
7. In the use of the reach forklift, special attention should be paid to the timely charging of the battery and the correct maintenance of the battery.
Pay attention to the method when charging the battery, not only to make the battery fully charged, but also not to cause the battery overcharge.
8. In the operation of the reach forklift, it is necessary to minimize the use of long-distance acceleration for a long time.
When the vehicle starts and the speed increases, hold the accelerator pedal. If the road condition is good, the vehicle will continue to accelerate.
When the vehicle needs to decelerate, relax the accelerator pedal and gently step on the brake pedal, which can make full use of the decelerating energy.
If the vehicle has regenerative braking function, the kinetic energy during deceleration can be recovered. When the vehicle is going down the ramp, do not disconnect the circuit of the driving motor, gently step on the brake pedal to make the vehicle run in the regenerative braking state, and use the kinetic energy of the vehicle to reduce the energy consumption of the battery.
9. When the vehicle is running, do not mistake the "forward, backward" direction switch for the steering switch.
Do not press the brake pedal to the bottom unless you need to decelerate urgently. In the process of vehicle operation,
if the battery is found to be insufficient (which can be obtained through the electricity meter, power shortage indicator and other alarm devices),
the battery should be charged as soon as possible to prevent excessive discharge of the battery.
10. During the operation of the reach forklift, it is necessary to pay attention to safety and avoid overloading; And usually do a good job of maintenance, do not run with fault, in order to avoid unnecessary accidents, remember safety first.
